This is a link party. With a giveaway. So make sure you link up your DIY / crafty posts to our party!
The rules of the linkup:
1. Only link DIY or craft posts. Any DIY or craft is accepted. {Link must go directly to your post, not your blog.}
2. Grab this button and place it somewhere within the post your linked up.
3. Visit some of the other people who have linked up.
For the giveaway: Amanda and I will choose the winner of the giveaway using random.org for the people who link-up. You must link-up to qualify. The link up will be open until September 22, 2012. The prize: It's a surprise!! But we promise, it's something awesome!
DIY Washer Bracelets
First you'll need to gather your supplies:
Ribbon (not too thick)
Scissors
Tape
Washers (different sizes are available, so choose the size you prefer)
Measure out your ribbon and cut. Allow a lot of extra wiggle room.
Tape the end of the ribbon to make threading easier.
Slide on your first and second washer.
Here's the tricky part: Take the taped end of your ribbon and thread it back through the first washer.
Make sure you pull it tight.
Now, weave the taped end of the ribbon back through the second washer like a figure 8.
Thread on your third washer. Weave the taped end of the ribbon back through the second washer. Then weave it back through the third washer making another figure 8 and pulling the ribbon tight. Continue this pattern until you've gotten the desired number of washers on your bracelet.
Trim the excess ribbon and tie around your wrist.
Voila. Washer bracelets. This can be adapted to a necklace if you'd like.
The Pinspiration:
Don't forget to add you link to join the party and enter the giveaway!
No comments:
Post a Comment